The lavatory drain gets its fair share of clogs, “mostly due to
human hair and soap scum, and sometimes an occasional toothbrush,” says
Bob Beall, president of Mr. Rooter Plumbing Youngstown, Ohio.
“Nine times out of 10, you can clear the lavatory drain by simply
removing the pop-up from the center of the bowl and cleaning off the
hair.”
Some sinks, such as bowl sinks, do not have a pop-up. “For these
models you can often auger straight down into the vertical part of the
trap,” says Mr. Rooter.
“However, your cable may not be able to get through the trap itself.”
Be sure to check the drainpipes for leaks after you’ve tried any
auguring.
“To rod a sink with a pop-up,” says Beall who offers consumers daily
plumbing tips, “go under the sink and unscrew the cap holding the lever
that activates the pop-up.” Then pull the lever straight back and out.
“Do not lose any parts,” says Mr. Rooter, the most referred plumber in
the world. Beall says, “Be wary of a washer that might come out as
well. If it does, reinsert it with the concave part facing out toward
the ball on the lever.”
Mr. Rooter’s Tip Of The Day
Tip #1 Remove the pop-up. This is where most clogs occur. If the pop-up comes out clean…
Tip #2 Find the clog in another location. If it comes out with a
mass of hair, clean it. With the pop-up removed, you can rod the line
straight down from the sink.
Tip #3 A fish-hook grabber may be used to pull out any debris and
balls of hair. It may be a good idea to forgo using the auger and go
straight to the P-trap. Put a bucket under the trap to catch the water
that’s in it. Then simply unscrew the two slip nuts and the trap will
fall away.
Tip #4 Clean the trap and make sure there is no blockage in the trap
line going into the wall. If you still can’t find the blockage, clean
the trap line.
Tomorrow Mr. Rooter will cover the topic of cleaning the trap line.
Mr. Rooter’s Daily Tips are provided by Mr. Rooter Plumbing. Subscribe today!
No comments:
Post a Comment